1. Please hang the alloy saw blade vertically on a dry shelf, please be sure to avoid wet places, and never put the alloy saw blade flat on the ground or shelf, as flat placement will cause the alloy saw blade to deform.
2. When storing saw blades, the saw blades should not be stacked together, and the saw blades should be placed in the original carton;
3. When using, you must bring protective covers, gloves, helmets, labor protection shoes, and protective glasses.
4. When installing the alloy saw blade, you must first confirm the performance and use of the saw table, and it is best to read the manual of the saw table first. In order to avoid misloading and causing accidents.
5. When installing the alloy saw blade, it is necessary to check whether the alloy saw blade has cracks, distortions, leveling, tooth loss and other phenomena before installation.
6. The serration of the alloy saw blade is super hard and sharp, and it is forbidden to collide and fall to the ground, so it must be handled with care.
7. After installing the alloy saw blade, it is necessary to confirm whether the center hole of the saw blade is firmly fixed on the flange of the saw table, and the washer must be sleeved when there is a washer; Then, gently push the saw blade with your hand to confirm that the blade is turning eccentricly. The diameter of the flange should be adapted to the saw blade, the size should be 1/3 of the diameter of the saw blade slightly larger, and the thin sheet should be a flange with a diameter of 1/2 saw blade, and the sawing effect is better;
8. The cutting direction indicated by the arrow of the alloy saw blade must be aligned with the rotation direction of the saw table. It is strictly forbidden to install in the opposite direction, as the wrong direction will lead to tooth loss.
9. Pre-rotation time: After replacing the alloy saw blade, it is necessary to pre-rotate for one minute before use, so that the saw table can be cut when it enters the working state.
10. When the saw blade is used for many times, the saw tooth of the saw blade should be cleaned up, and the resin, wood chips and other debris attached to both sides of the saw tooth should be removed, otherwise it will have a greater impact on the processing effect of the saw blade;